BIO-FIGHTER
®
NOMAD, NOMAD 2 INSTALLATION & OPERATION MANUAL
6
Burn Hazard.
During replacement, allow lamps to cool 10 minutes
before removing them. Personal injury may result.
WARNING
Mercury Hazard. Do Not Break.
Each UV-C lamp contains a small amount of Mercury.
May cause redness or irritation. Use proper disposal
techniques in case of breakage.
WARNING
CONNECTING TO POWER
With the Nomad/Nomad 2 installed, connect
power cord to proper power. If installing model
with whip-type power cord see Fig. 6 below for
power connection. Use the viewport to verify
lamp operation. A blue light should be seen.
INSTALLING THE VIEWPORT
The Nomad/Nomad 2 comes with a UV-C safe
viewport(s) that must be installed separately.
To install the viewport, select a location near
the Nomad/Nomad 2 installation and drill a
1/2" hole in the duct. Then press the viewport
into the hole. For a Nomad 2 installation, make
sure each viewport is positioned near each
lamp location.
OPERATION
The Nomad/Nomad 2 should be operated
continuously to extend the life of the lamp(s),
and to increase the effectiveness in disinfect-
ing the location selected.
INSTALL REMOTE DOOR INTERLOCK SWITCH
(Optional accessory #06150.)
Mount the remote door interlock switch so that
power to the device is automatically discon-
nected anytime the air handler access panel is
opened.
1. Remove the black remote interlock hole cap
from the side of the Nomad/Nomad 2.
2. Insert remote door interlock switch wire through
hole. Secure with strain relief. Install male and
female connector to remote door interlock switch
wires and connect to UV-C light.
3. Mount remote door interlock switch and actua-
tor to access panel opening.
4. Check operation. Device should turn off when
access panel is opened.
Note:
Remote door interlock switch includes 5 ft(1.5m)
120V power cord with custom connectors. If device is
installed more than 5 ft(1.5m) away from remote door
interlock switch, field wiring will be required in accor-
dance with national and local codes.
Connect green wire
to ground.
Whip-type
power cord
Connect black
and white wires
to proper power.
Fig. 6
Power connection for models with whip-type power cord.
UV-C Light Hazard.
UV-C light can cause temporary or permanent loss of
vision, and sunburn. Take precautions to protect eyes
and skin from direct exposure.
WARNING
Clean lamp(s) prior to installation.
Failure to remove dirt and fingerprints from the
lamp(s) could shorten their lifespan.
CAUTION
