18
Parts & Operations Manual
Labrador
Replacing the squeegee blades
•
Lower the squeegee.
•
Remove the suction hose from the squeegee
•
Lift the squeegee fastening levers.
•
Remove the squeegee from the slots on the support.
•
Open the hook (Fig. 20, ref. 1).
•
Push the two blade pressing devices (Fig. 20, ref. 2) outwards,
then remove them.
•
Remove the blade.
•
Reuse the same blade by reversing the edge in contact with the floor
un til all four edges are worn out, or replace with a new blade, fitting
it onto the screws on the body of the squeegee.
•
Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins,
then push the blade pressing devices inwards.
•
Close the hook again.
•
Replace the squeegee on its support, following the instructions described previously.
Periodic Checks
Checks
Daily
Operations
Weekly
Operations
Six Monthly
Operations
Empty and wash the dirty water tank
X
Clean the squeegee blades and check them for wear
X
Check that the suction hole in the squeegee is not blocked
X
Recharge the batteries
X
Clean the dirty water tank float
X
Clean the suction motor air filter
X
Clean the water/detergent tank filter
X
Clean the suction motor hose
X
Clean the dirty water tank and the solution tank
X
Check the battery electrolyte level
X
Have the electrical circuit checked by qualified cleaning personnel
X
Periods of Inactivity
If the machine is not used for some time, for example, on display in a showroom or stored in the warehouse for a period or more
than one month, the following operations are required:
•
Recharge completely the batteries. During long periods of inactivity, you should charge the batteries regularly (at least
once every two months) to keep them constantly at maximum charge.
•
Disconnect the batteries from the machine.
•
Unplug the battery charger (if present) from the mains power supply.
•
Remove the squeegee and brushes (or abrasive disks), wash them and put them away in a dry place (preferably in a bag
or wrapped in plastic film) away from dust.
•
Make sure the tanks are completely empty and perfectly clean.
