Dustbane 19669, Parts & Operation Manual

ENGLISH

  Grounding 

Instructions

This air mover must be grounded while in use to protect the operator from electric shock. This machine is built    

with a 3-wire cord and a 3-prong grounding-type plug (Figure 1) to fit a properly grounded receptacle.

Before using this machine, make sure a properly grounded, 3-hole electrical outlet is available. Never assume that all 3-hole outlets 

are properly grounded. Check before use. 

Correct a faulty grounding before proceeding.

EXTENSION CORDS ARE NOT RECOMMENDED

The air mover is built with a 20-foot, 16/3-gauge safety power cord. Use of any extension cords is NEVER RECOMMENDED.

Operating Tips

• For indoor use only.

• Adjust the air mover to the desired position for operation by tipping the machine onto one of the three flat faces of the    

   heavy-duty plastic chassis. The balanced machine design assures stable positioning.

• Plug the power cord into a grounded outlet.

• This air mover has three (3) power settings controlled at the side of the machine. Turn the power knob on the side of the   

   air mover to the desired speed.

• 1 = 780 RPM, 2 = 1000 RPM, 3 = 1500 RPM. To turn the air mover off, turn the power knob to the off position.

• Never pull on the cord to disconnect or turn off the motor.

Storing the Air Mover

• Wind the cord around the carrying handle.

• Store in the upright position in a dry area.

• Check and clean after each operation. Remove soil and chemical buildup. Use vacuum and soft brush to remove soils from  

  motor vents and fan blades.

• Wipe the outside chassis with a mild cleaner. Never wash the outside of the air mover with flowing water. Make sure that 

  the air intakes are not blocked.

• Check switches for proper operation. Call a trained electrician to repair or replace damaged cords and plugs.

• Report problems and repair promptly.

  Troubleshooting 

Guide

Never operate this air mover when the equipment is not performing as expected or when any part is visibly  

damaged. When repair is needed, take the equipment to an authorized service center.

Air Mover will not run

• Circuit breaker tripped in building. Check and reset.

• Equipment unplugged. Check plug at wall and plug in.

• Power cord failure. Seek authorized repair services.

• Motor sparks or smokes. Seek authorized repair services.

High vibration

• Air Mover fan blades are damaged or broken. Seek authorized repair services.

• Motor bearings are worn. Unplug the air mover and spin the fan blades. If the spinning causes noise or restricted  

  movement, replace the air mover with new equipment.