Dustbane Gladiator 1050 Ride-On, Operation Manual

5

ENGLISH

Preparing The Machine

The machine calls for a set of 24 V batteries. The machine can be supplied in three options:

1) 

Batteries supplied with the machine, fitted and filled with acid, ready for use.

2) 

Batteries supplied and fitted dry (without the liquid electrolyte).

3) 

Batteries not supplied. Raise the bonnet carrying the seat by pushing it forward towards the steering wheel and check which 

option applies to your machine.

If the batteries are fitted, open up one of the vent caps of each 

battery and check if they are filled with electrolyte.

1)

  If the batteries are already filled:

a. 

Check the level of electrolyte and top up if necessary (use 

only distilled water).

b. 

Recharge (see the MAINTENANCE section and the battery 

instruction handbook).

2)

  If the batteries are supplied without liquid (i.e. dry), they must 

be filled with sulphuric acid (density from 1.27 to 1.29 kg at 25°C), according to the instructions given in the next paragraph and 

in the battery handbook.

Filling batteries with acid: Pay particular attention when you are handling sulphuric acid. This substance is corrosive. If it comes into 

contact with your skin or eyes, wash with plenty of fresh water and seek medical assistance. Batteries must be filled in a ventilated 

area.

Fill the cells (or single elements) of the batteries with acid. The correct 

level is indicated in the battery instruction handbooks. After an hour, 

top up the cells, if necessary, with more acid.

Let the batteries rest – with the machine stopped – for another hour 

and then refill, in accordance to the instructions given in the handbook 

provided with the battery (refer to the “MAINTENANCE” section). During 

the charging operations, all battery caps must be open.

3)

  If the machine has been supplied without batteries, these must be purchased and installed 

accordingly. Competent battery specialists should preferably be 

contacted to choose and install the new batteries.

The electrical connection cables supplied with the machine may be used to connect the 

batteries. Once the batteries have been installed, connect the battery connector to the 

machine. 

Removing The Batteries

When removing the batteries, the operator must be equipped with suitable personal protection devices (gloves, goggles, overalls, 

safety shoes, etc) to reduce the risk of accidents.

Make sure the switches on the control panel are in the “0” position (off) and the machine is turned off. Keep away from naked flames, 

do not short circuit the battery poles, do not cause sparks and do not smoke. Proceed as follows:

• 

Disconnect the battery wiring and bridge terminals from the battery poles.

• 

If necessary, remove the devices fixing the battery to the base of the machine.

• 

Lift the batteries from the compartment using suitable lifting equipment.