10
ENGLISH
Filling the water/detergent tank
Fill the tank through the opening provided (figure below). The machine is equipped with a graduated measuring cap that can be
used to dilute the detergent inside the tank. If the tank is empty, the display shows the corresponding alarm, see “Display alarms” .
The quantity of water/detergent in the tank can be checked using the level tube on the side of the machine (figure below).
Finishing work
IMPORTANT!
Empty the dirty water tank and recharge the batteries
When ending work, switch off the machine at the main switch. The machine does not have a parking brake as it is fitted with an
electric brake, which automatically brakes the machine when the drive pedal is not pressed.
Moving the machine when not in operation
Proceed as follows to move the machine.
•
Select the direction of travel.
•
Press the accelerator pedal.
If the machine cannot be moved using the electric drive, the machine can be pushed after having
disengaged the electric brake, see “Pushing and pulling the machine”.
Periods of Inactivity
Proceed as follows to prepare the machine for extended periods of inactivity.
•
Remove the squeegee and brushes (or abrasive disks), wash them and put them away in a dry place (preferably in a bag
or wrapped in plastic film) away from dust.
•
Make sure the tanks are completely empty and perfectly clean.
•
Disconnect the machine from the power supply.
•
Completely recharge the batteries and deposit them in the battery store. During long periods of inactivity, you should
charge the batteries regularly (at least once every two months) to keep them constantly at maximum charge.
WARNING!
If you do not charge the batteries regularly, they may be irreparably damaged.
