S 11000, S 21000, S 32000, S 34000, S 46000
S 11000 EX, S 21000 EX, S 34000 EX - 33
Part No 94160-G
Test Running
Check that the vacuum producer is correctly installed
and inlet and outlet connected to the duct system. The
tubing between the
fi
lter unit and vacuum producer must
be free from particles. Objects in the vacuum producer
can cause failure.
Check discharge arrangement. No leakage can be al-
lowed.
Cleaning of the
fi
lters
The
fi
lters of the dust separator are cleaned automati-
cally.
This is done at different times, depending on
con
fi
guration of the system.
When the
fi
lter is cleaned a number of very clear air
pulses, with a few seconds interval, should be heared.
If the system does not give full suction after
fi
lter clea-
ning, it is recommended that the
fi
ne
fi
lters are changed.
Use only original
fi
lters.
The condition of the
fi
lters can be checked by measur-
ing the pressure drop over the cleaned
fi
lters with a
manometer (Part No 8283). If the manometer registers a
value higher than 3 - 4 kPa the
fi
lters should be chan-
ged.
Some time after the installation there should be a
follow-up check on all screws and nuts.
Service
The
fi
lters should be changed at least once per year.
Only original
fi
lter is allowed. Use breathing protection
during the
fi
lter change. Do not expose unprotected
persons to harmful dust.
-
Turn off and lock the disconnect of the vacuum
producer.
-
Use breathing protection.
-
Lift off the top of the
fi
lter unit.
-
Lift out the
fi
lters and seal them in a plastic sack.
-
Lift in the new
fi
lters, and connect the top.
If the extracted dust is collected in a plastic bag, the bag
should be changed when the dust level is 5 cm under
the plastic
fl
ap at the bottom of the
fi
lter unit. The plastic
sack must be sealed when removed from the
fi
lter unit.
If the dust is collected in a container, it should be chan-
ged or emptied before it is completely full.
Filterchange
Filter Part No
Number
S 11000
4292
1
S 11000X
4284
1
S 11000 EX
429206
1
S 21000
4284
1
S 21000 EX
429206
1
S 32000
4292
2
S 34000
4292
4
S 34000X
4284
4
S 34000 EX
429206
4
S 46000
4284
6
EN
G
LI
S
H