DV Power RMO200, Manual

23

RMO200                                                                                                                                                        

Remote Control 

8.2  Operational Components 

8.3  Measuring with the Remote Control Unit 

Testing with the Remote Control Unit is much like the testing procedure 
with RMO itself, and is therefore only outlined here: 

–   Connect the Remote Control Unit to RMO, 
–   Connect the Remote Control Unit to a test object, 
–   In the RMO 

Sing 

menu, define a test parameters for the test, and press   

     ENTER

 to change to the 

Test

 menu, 

–  The flashing green LED indicate that RMO is now ready to start the test. 

            –  Press the

Ω

/STOP

 button once more to start the test. While the test is running,   

   the green and red LED flash alternately. To stop the test prematurely, press          
   the 

Ω

/STOP

 button once more.  

  Once the test is finished, RMO automatically changes to the 

Result

 menu to   

    display the test results. The green LED lights up continuously. 

If an error occurred during the test, the red LED lights up continuously, and the    
display presents the according error message. 

Provided that, for a series of tests, the same test current is fed through the test       
object, multiple tests can be carried out with the Remote Control Unit.                
Simply press the 

Ω

/STOP

 button again to repeat the procedure. 

If different test parameters are required, set them on RMO directly, and start the   
new test by pressing the 

Ω

/STOP

 button again. 

Sockets to connect the Remote Control Unit directly to a test 
object "Voltage Sense +" and "Voltage Sense -" 

Depending on the situation, 
the 

Ω

/STOP

 button has 

varying functions: 
• When the green LED   
  flashes a new test can   
  be started by pressing   
  this button 
• When the green LED   
  lights continuously,   
  pressing this button will   
  prepare RMO for a new   
  test, using the test 
  parameters set on RMO. 
• While a test is running   
  (the green and the red   
  LEDs flash alternately),   
  pressing this button   
  stops the test immediately. 

The LEDs of the Remote 
Control Unit function 
synchronized with the ones 
of RMO. 

 Green LED 

• Flashes when a test can   
  be started. 
• Flashes alternately with   
   the red LED during a test.
• Lights continuously when 
  a test is done. 

 Red LED 

• Flashes alternately with   
   the green LED during a   
   test. 
•  Lights continuously in   
   case of operational error.