Page 6 of 21
Display
: There is a wide selection of displays in the marketplace that are suitable for
use with the ViewStream 500. Users are however recommended to consider the
following:
o
Video resolution: As a general rule it is recommended to use a display of the
same resolution as the media to be played. If this is not possible although the
media player supports scaling choosing a display with a good scaling engine will
provide flexibility and optimal results.
o
Aspect ratio: Many displays are widescreen with an aspect ratio of 16:9. However
PAL/NTSC is 4:3. Consequently video output to widescreen displays may be
stretched or shown with black bars. If possible this is best corrected during the
video production and encoding process.
OSD Configuration menu
: In Configuration mode, you can read MAC address/Firmware
version of the unit. And setup master volume, system clock, time zone and options for Datalog
and OSD message, etc. To configure, you may need a 8-button keypad or touch screen or IR
remote handset.
IR Remote handset
Configuration Mode
MAC: 000562010406
Kernel Version: V2.83.01.10
Version: V1.08.10 RP-500
Volume: 16
TZ:+0 YY:09 MM:11 DD:19 hh:15 mm:54 ss:50
OSD: ON Datalog: ON
System Message: ON
Save and Exit
8-key Button
7
8
1
8-segment Touch screen
2
3
4
5
6
To enter configuration mode, holding Button 8 (or “Display” key on IR handset) for 30 seconds
while power on the unit.
Change the Volume
Press Button 8 (or “Display” key on IR handset) to select
Volume
.
Press Button 6 / 7 (or “+” / “-“ key on IR handset) to change the volume level (range from 1 to
32)
Press Button 8 (or “Display” key on IR handset) to select
Save and Exit
Press Button 6 (or “-“ key on IR handset) to exit without save.
Press Button 7 (or “+” key on IR handset) to save and exit.
Reboot the unit.
Change the Time Zone
Press Button 8 (or “Display” key on IR handset) to select
TZ
.
Press Button 6 / 7 (or “+” / “-“ key on IR handset) to change the time zone value.
Press Button 8 (or “Display” key on IR handset) to select
Save and Exit
Press Button 6 (or “-“ key on IR handset) to exit without save.
Press Button 7 (or “+” key on IR handset) to save and exit.
Reboot the unit.