17
pair the code of the new remote control. If the code pairing has been unsuccessful,
the red LED light flashes for 20 seconds and then goes out, stop the code pairing
and go to sleep; at this time, press any Button to wake up and re-pair the code.
⚫
After the code is successfully matched, you need to select the camera address to
control it
2
）
Clear Code Data
Press the "Settings" "#" Button from light off to flashing, the receiving end is
powered off and then powered on. The LED is off, indicating that the paired data is
cleared successfully
3
）
Enter Sleep Mode and Wake Up
If there is no operation in the working state, it will immediately enter the sleep mode,
and press any Button to wake up.
