Displayed on the home screen.
Temperature Display
System On / Off
DVS® EC Heat Transfer System Controller User Guide
Turning the system
ON
or
OFF
:
Air Supply Setting
Main Display
Will show fan operation
Indication.
Moving symbol = Fan On
Static symbol = Fan Off
Press for 2 seconds to
turn the system On / Off.
Press to check Room
Temperature (measured
at the control panel) and
Air Supply Temperature
(measured in the system
fan). The associated
LED will indicate which
temperature you are
viewing. You can toggle
between each by pressing
the Temperature Display
button more than once.
To increase or
decrease Air
Supply rate press
the Increase or
Decrease button.
Air Supply
See Temperature
Display.
LED Indicators
Pressing the SYSTEM ON / OFF
button for 2 seconds
will turn the system off (display and LED’s off, fans off).
Another press will turn the system back on.
Increasing the number on the AIR SUPPLY Setting will
increase the airflow from the heat source to your
supply vents. Pressing the
or
buttons will
change the AIR SUPPLY rate. After setting the supply
rate the screen will return to the fan ON / OFF indication
after 10 seconds.
Phone 0800 387 387 | www.dvs.co.nz
Press and hold the
button for 5 seconds to access
the FAN START TEMPERATURE
.
Both LED’s for Air Supply
Temperature and Room Temperature will flash.
The display will show the current start temperature.
Pressing
or
will change the start temperature.
If set to OF, the fan will run continuously.
After 15 seconds without pressing a button, the menu will
exit and return to the Fan ON / OFF display.
Press and hold the
button for 5 seconds to access the
manual override function. This allows you to run the system
for a set amount of time, ignoring the room temperature.
After pressing and holding the
button for 5 seconds,
pressing the
or
buttons will select 15, 30, 60, 90
or 0 (minutes). When you have selected the required time,
no further input is needed. After 15 seconds the system
will return to the FAN ON or FAN OFF indication.
After the timed period is completed the system returns to
normal operation.
Transfer Start Temperature
(preset to 22 degrees)
The fan will only operate
when the temperature at
the control panel exceeds
the Set Temperature.
Manual Operation
