Installation and Mounting
5
Torx T10 pin-in security bit, 3-1/2” (90mm) in length
Hex wrench
RJ45 connector
RJ45 crimping tool
Coax cable
Coax cable cutter/stripper
BNC connector
BNC crimping tool
Figure 2: Recommended Tools
3.3.
Preparing the Cables
To prepare the camera cabling
Disconnect power from any previously installed cables.
Use a #2 Phillips head screwdriver to pierce a hole in the center of the
cable gland.
If needed, pierce the smaller holes on the outer perimeter of the cable
gland membrane for AC/DC power.
Remove the electric nut from the sealing gland.
Place the O-ring on the threaded end of the cable gland to insure a
good seal.
If using existing cable, cut off the RJ45 or BNC connector.
Feed the cables through the components in the following order:
Summary of Contents for ioimage CT-5320F
Page 2: ...CT 5320F CT 5640F Fixed Thermal Camera QIG ii...
Page 22: ......
