CT-5320F/CT-5640F Fixed Thermal Camera QIG
4
3.1.
Preparation
Read the instructions in this chapter thoroughly before installing the camera.
Following are additional considerations for outdoor installation:
Always use weatherproof equipment, such as boxes, receptacles,
connectors, etc.
For electrical wiring, use the properly rated sheathed cables for
conditions to which the cable will be exposed (for example,
moisture, heat, UV, physical requirements, etc.).
Plan ahead to determine where to install infrastructure
weatherproof equipment. Whenever possible, ground components
to an outdoor ground.
Use best security practices to design and maintain secured camera
access
, communications infrastructure, tamper-proof outdoor
boxes, etc.
To minimize the effects of EMI (electromagnetic interference) and RFI
(radio frequency interference), consult your reseller.
3.2.
Items Required for Installation That Are Not
Supplied
The following items are required for installation, but are
not
included in the
package:
Power source (PoE switch, 12-24VDC or 24VAC power supply)
Shielded Twisted Pair (STP) cable if using a PoE switch
Cat 5 Ethernet cable for network connection without a PoE switch
Tripod or mounting bracket for mounting the camera
One #2 Phillips head screwdriver
Two open-end, 1-inch (25.4mm) wrenches or adjustable wrenches
One 6-inch (152mm) scale or ruler
Electric or manual torque screwdriver set to 10 inch-pounds
(1.23 Newton meters)
Summary of Contents for ioimage CT-5320F
Page 2: ...CT 5320F CT 5640F Fixed Thermal Camera QIG ii...
Page 22: ......
