Installation and Mounting
11
3.6.
Attaching the Camera to an Analog Device
In order to prevent video signal distortion, the supplied ground loop isolator must
be installed between the analog out connector on each camera and an attached
analog device if:
You are connecting the camera to an analog device and
You are connecting more than one camera on the network segment
Figure 14: Ground Loop Isolator Installation
3.7.
Assembling the Camera Components
Refer to
(page 1) for illustrations and a description of the
components mentioned in this section.
To assemble the camera components
Attach the base mount to the camera using 8 of the #6 screws.
Using the electric screwdriver and the Torx T10 security bit, tighten the
8 fasteners to about 10 in-lbs. (0.9 newton meters) of torque.
Using the electric screwdriver and the Torx T10 security bit, tighten the
fasteners to about 10 in-lbs. (1.23 newton meters) of torque.
Connect the cables to the respective connector:
Ethernet port
Analog video out
Summary of Contents for ioimage CT-5320F
Page 2: ...CT 5320F CT 5640F Fixed Thermal Camera QIG ii...
Page 22: ......
