DVZ Biomaster PLUS Series Final Documentation Download

Page: 93 / 145

Issue: 03.05.2011

CIP-Process for DVZ-SKA-”BIOMASTER”-PLUS

Page 3 of 6

SKA-PLUS-ANNEX P1-Eng

Personnel qualification and training

All personnel involved in the operation,
maintenance, inspection and installation of the unit
must be fully qualified to carry out the work involved.
Personnel responsibilities, competence and
supervision must be clearly defined by the
operator.If the personnel in question is not already in
possession of the requisite know-how, appropriate
training and instruction must be provided. If
required, the operator may commission the
manufacturer / supplier to take care of such training.
In addition, the operator is responsible for ensuring
that the contents of the operating instructions are
fully understood by the responsible personnel.

Non-compliance with safety instructions

Non-compliance with safety instructions can
jeopardize the safety of personnel, the environment
and the machine / unit itself. Non-compliance with
these safety instructions will also lead to forfeiture of
any and all rights to claims for damages. In
particular, non-compliance can, for example, result
in:
- failure of important unit/system functions,
- failure of prescribed maintenance and servicing

practices,

- hazard to persons by electrical, mechanical and

chemical effects,

- hazard to the environment due to leakage of

hazardous substances.

Safety awareness

It is imperative to comply with the safety instructions
contained in this manual, the relevant national
health and safety regulations and the operator’s own
internal work, operation and safety regulations.

Safety instructions for the operator / user

- Any hot or cold components that could pose a

hazard must be equipped with a guard by the
operator.

- Guards which are fitted to prevent accidental

contact with moving parts (e.g.coupling)must not
be removed whilst the unit is operating.

- Leakages (e.g.at the shaft seal) of hazardous

media handled (e.g.explosive, toxic, hot)must be
contained so as to avoid any danger to persons or
the environment. All relevant laws must be
heeded.

- Electrical hazards must be eliminated.(In this

respect refer to the relevant safety regulations
applicable to different countries and/or the local
energy supply companies.)

Safety instructions for maintenance,inspection
and installation work

The operator is responsible for ensuring that all
maintenance, inspection and installation work be
performed by authorized, qualified specialist
personnel who are thoroughly familiar with the
manual.
The pump must have cooled down to ambient
temperature, pump pressure must have been
released and the pump must have been drained.
Work on the machine / unit must be carried out only
during standstill. The shutdown procedure described
in the manual for taking the unit out of service must
be adhered to without fail.
Pumps or pump units handling media injurious to
health must be decontaminated.

Immediately following completion of the work, all
safety-relevant and protective devices must be re-
installed and / or reactivated.
Please observe all instructions set out in the chapter
on “Commissioning/Start-up”before returning the
unit to service.

Unauthorized modification and manufacture of
spare parts

Modifications or alterations of the equipment
supplied are only permitted after consultation with
the manufacturer. Original spare parts and
accessories authorized by the manufacturer
ensure safety. The use of other parts can invalidate
any liability of the manufacturer for consequential
damage

Unauthorized modes of operation

The warranty relating to the operating reliability and
safety of the unit supplied is only valid if the
equipment is used in accordance with its designated
use as described in the following sections of this
manual. The limits stated in the data sheet must not
be exceeded under any circumstances.

Installation at site

Safety regulations

Electrical equipment operated in hazardous
locations
must comply with the relevant explosion protection
regulations.This is indicated on the motor rating
plate.
If the equipment is installed in hazardous locations,
the applicable local explosion protection regulations
and the regulations of the test certificate supplied
with the equipment and issued by the responsible