www.SitePro.us.com
6
7
OPERATION
•
Protect the measuring tool against moisture and
direct sun.
•
Do not expose the measuring tool to extreme
temperatures or variations in temperature.
Power On and Off
•
Press the “
ON/OFF
” button to switch the digital
level on or off.
Holding a Measured Value
•
Press the
HOLD
button. The current measured
value on the display is held. An ‘H’ will appear on
display indicating that the measurement is held.
•
Press the
HOLD
button again to start a new
measurement.
Changing the Unit of Measure
The default unit of measurement is degrees ( ° ). It is
possible to change between the “ ° ”, “inches/feet” and “ %
” units of measure at any time.
•
Press the
“ ° in/ft”
button to alternate between
the modes of measurement.
Sound
The acoustic signal can be switched on and off by pressing
the “
SOUND/LIGHT
” symbol button on the display.
•
Press again to deactivate the sound option.
NOTE: When the Sound has been activated, the Digital
Level will beep at every 45° that it moves.
LCD Back Light
• Press and hold the “
SOUND/LIGHT
” button for 2
seconds to activate the LCD Back Light for the
display.
•
Press and hold the button down again for 2 sec
-
onds to deactivate the LCD Back Light Display.
Rotation of the Reading
Depending on the position of the digital level, the mea-
sured value and the unit of measure are indicated in the
display rotated by 180°. Thus, the indication can also be
read for overhead work.
Set Relative Angle Measurement
•
Press the
RESET
button.
•
The LCD display will show 0.0°, using the present
angle as the initial angle. The later observed
results will be the relative value.
•
Once the level has been turned OFF, it will return
to the absolute measurement angle mode.
BATTERY VOLTAGE INDICATOR
The LCD display has four different settings to indicate the
voltage of the battery.
NOTE: When the battery has a charge of less than 7V, the
unit will beep every ten seconds to indicate that it is time
to replace the battery.
Image
Voltage
> 8V
< 8V (
±
0.2V)
< 7.5V (
±
0.2V)
< 7V (
±
0.2V)
