www.SitePro.us.com
9
Battery recharging
•
Battery should be recharged with the special charger. Insert the battery charger
into the power source with 220V or 110V, remove the on-board battery from the
main body, and connect the plug of the charger to the charging connector on the
battery. The indicating red lamp is on that indicates the battery is been recharging
and recharge will be completed after green lamp indicated. Then remove the plug
from the charging connector.
SETUP INSTRUMENT
•
Adjust the tripod legs to obtain a suitable height.
•
Make sure the surveyed point is under the centering hole of tripod head.
•
Level the tripod head and lock.
•
Put the instrument on the tripod head and lock with the screws.
LEVELING
Level the instrument with circular vial
•
Turn B and C to let the bubble move to centre line.
•
Turn knob A to let bubble stay at center of circular vial.
Level the instrument with plate vial
•
Loose level clamping knob and turn knob B and C
to let bubble center.
•
Rotate the instrument 90°and then turn knob A
to let bubble center
•
Repeat above steps in each 90 degrees
rotating,and check if bubble have been centered
CENTERING THE INSTRUMENT
Turn on laser plummet, and make sure the laser
land mark can been seen clearly, make sure that
the land mark coincides with the center of the
reticule,then lock the instrument. Repeat above
steps and make sure the land mark definitely
coincides with the center of the reticule.
