9
3. SW12 VDC OUTPUTS
The DuoVision
™
Processor has two sw12 VDC outlets (2.5 mm DC plug)
labeled as RY1 and RY2. These outlets may be used to trigger a relay in an electric
device. Each output provides 100 ma DC current. See
Relay Setup
menu for more
details.
4. RGB INPUTS
The RGBS1 and RGBS2 inputs (D-sub 15) are provided for High-Definition (480p,
580p, 720p, 1080i) sources and computer graphics with VGA, SVGA, XGA, and
WXGA resolution. For computer graphics with VGA, SVGA, XGA, or WXGA, it is
recommended to set the computer to 60 Hz vertical frequency.
Pin No.
Signal Name
Pin No.
Signal Name
Pin No.
Signal Name
1
Data 2-
10
Data 1+
18
Data 0+
2
Data 2+
11
Data 1 / Shield
19
Data 0 / Shield
3
Data 2 / Shield
14
+5V Power
22
Clock Shield
6
DDC Clock
15
Ground
23
Clock+
7
DDC Data
16
Hot Plug Detect 24
Clock-
9
Data 1-
17
Data 0-
The following are the pin assignments for the DVI connectors:
Pin No.
Signal Name
Pin No.
Signal Name
Pin No.
Signal Name
1
Red
6
Ground
11
2
Green
7
Ground
12
3
Blue
8
Ground
13
Horz. SYNC
4
9
Ground
14
Vert. SYNC
5
10
15
The following are the pin assignments for the D-sub 15 pin connector:
5. RS-232 COMPUTER INPUT
The RS-232C serial interface is provided for external control of the DuoVision
™
from a central controller, such as a Home Theater control computer, Smart Home
automation system, etc.
For D-sub 9 pin connector pin-out and RS-232 command list, please refer to
“
DuoVision
™
RS-232 Control
” section.
6. S-VIDEO INPUTS (S1, S2)
The S1 and S2 inputs are provided for NTSC (480i) or PAL (580i) video sources,
such as off-air tuners, satellite systems, cable boxes, SVHS VCR and DVD players.
S-Video inputs, instead of composite video inputs, are recommended for use with
DVD players and satellite systems.
Summary of Contents for DuoVision
Page 1: ...DuoVision DuoVision 1 3 Printed in USA...
Page 2: ......
