- 17 -
Convergence Movement
During convergence there are two modes: cursor movement and circuit adjustment. When you start the
convergence process the cursor appears as a solid box. When you see this type of cursor you can use the
/ / /
arrow buttons on the remote to move the cursor to the point on the screen requiring adjustment. To
make a convergence adjustment press the
“SEL”
button on the remote and note that the cursor will change
to a double outline box.
During the convergence process the
“SEL”
button is used to change between cursor movement and
convergence adjustment.
Red Convergence
Since the green channel is your master reference, the first step is to converge the red channel to the green.
Before starting, take a moment to look at the cross hatch display on the screen. A perfectly converged set
will show the cross hatch as totally white over a black background. Of course, since the set has not yet been
converged, you will see areas of the screen where red or blue lines will separate from the green reference.
Make a mental note of the areas where there is the greatest amount of divergence of red from green, as
these are areas where you will want to pay special attention to convergence.
To proceed to the next step follow the on screen message and press
“ENTER” or "SEL"
once to start the
process and a second time to confirm the operation.
Before moving the cursor first look at the screen note that you will see a mostly yellow crosshatch, but there
will be areas where you will see separate green or red lines. Those are the areas you will need to carefully
converge.
Blue Convergence
The process for blue convergence is similar to that for red convergence, except that in this case the blue
channel will be adjusted using the red as a reference.
The process for cursor movement and convergence adjustment for blue is identical to that for red. Press the
“ENTER” or "SEL"
button on the remote to switch between the double outline box for adjustment and the
solid box for movement. Use the
/ / /
arrow buttons on the remote to make the convergence
adjustments or move the cursor location.
When all blue convergence adjustments have been made, press
“MENU”
to return to the master
Convergence menu
, and press it one more time to go to the main
Adjust menu
.
