- 2 -
Table of Contents
Safety Information ___________3
Important Information for the User___________________4
Specifications ___________5
Introduction ___________6
Pre Installation Preparations________________________7
Signal Connections___________________________________7
Front Panel Connections __________ ______8
Preparation for Adjustment___________________________9
Remote Control Operation __________10
Initial Set Up and Adjustment_______________________11
Focus Adjust Menu ________________11
Geometry Adjust Menu ________________13
Convergence Adjustments ________________17
Gray Scale Adjustment ________________20
Brightness Adjustment ________________21
Contrast Adjustment __________21
Center Convergence __________21
Centering Adjustments ________________21
Blanking Adjustments __________22
Size Adjustments ________________22
Source Memory Entry __________22
Global Setup Adjustments __________23
Power On Control ________________23
Menu Access ________________23
Menu time-out
__________24
White Balance Control
__________24
Scan Reversal
__________25
Screen Size Change Procedures ________________27
HD-700 Projector’s RS232 Control____________________28
Service & Warranty__________________________________29
WARNING
HAZARDOUS VOLTAGE
DO NOT OPEN
ATTENTION
COURANT ELECTRIQUE
NE PAS OUYRIR
CAN SHOCK, BURN OR CAUSE SEVERE INJURY OR DEATH. DO NOT
REMOVE COVER OR BACK PANEL. REFER SERVICING TO QUALIFIED PERSONNEL.
!
.
DWIN Electronics, Inc.
710 N. Mariposa St.
Burbank, CA 91506
Tel: 818-239-1500
Fax: 818-239-1506
www.dwin.com
info@dwin.com
This manual and all information pertaining to circuit
designs, internal operating software and industrial
design are Copyright © by DWIN Electronics Inc.
All Rights Reserved.
Any reproduction or distribution is strictly prohibited.
