- 22 -
Size Adjustments
The size adjustments are the final picture adjustment. They define the size of the picture within the blanking
area previously established. These adjustments have the impact of stretching and/or compressing the
picture. To change the picture size, press “
MENU
” to call up the Main Menu, and press “
6
” to access Size
control screen. Use the
/ / /
directional arrow buttons on the remote until the picture is sized to your
requirements.
Source Memory
Once all of the adjustments have been made to establish the picture parameters, they are saved under a
particular name so that these settings may be quickly recalled at a later time. This allows you to create
different settings for the same input source, for different characteristics such as aspect ratio, blanking, gray
level, etc.
To switch to a different source memory for the same input start at the
Main menu
then press
"7"
for
"Source".
A list of preset memories will appear. Press the corresponding number to switch to the desired
source memory.
You can also access the
"Source"
memory list by pressing the
"GUIDE"
button on the remote control.
Global Setup Adjustments
In addition to the settings that must be set individually for each input source, the HD-700 has a number of
global settings that address certain aspects of the projector’s operation. They should be adjusted to the
preferences of the end user before the set is delivered.
1. Power On Control
This setting permits the HD-700 to turn on automatically whenever a sync signal is present at the “H/C” input.
This means that it will be in a standby mode when no signal is present, and it will instantly display a picture
when you turn on the feed device such as a computer, decoder, doubler, quadrupler or multiplier. When the
signal is removed the picture will go dark and the unit will return to a standby mode.
To place the unit in the
“Auto”
mode, press “
MENU
” and then Press “
9
” to go to the Set Up menu. Check to
see that the word
“Auto”
is highlighted. If it is, the unit is already in the automatic mode and no further
adjustment is required. If the word
“Manual”
is highlighted, press to change the setting.
To move the unit back into the
“Manual”
mode, press
until the word
“Manual”
is highlighted. In this
condition the projector must be manually turned on with the remote control each time it is used.
2. Menu Access
-Video Source-
1. Name: Anamorphic
31.5KHz 60Hz
2. Name: Letterbox
31.5KHz 60Hz
- Set Up - HD700-45-FF Source
DVD
1. Power On:
Auto
Manual
2. Menu Access:
Enabled
Protected
3. Direct Source:
On
Off
4. Mounting:
FF
FC
RF
RC
5. Copy, Rename, or Delete Video Memory
Use
Ω
or
ς
to change preferences.
6. -Size-
Source
85
DVD
85
