- 26 -
Table 1
Connector Settings Horizontal
Vertical
Front Floor
H2
V2
Front Ceiling
H1
V1
Rear Floor
H1
V2
Rear Ceiling
H2
V1
Main Board
H1 H2 RED GREEN BLUE
V2
V1 V
H
IMPORTANT NOTE:
CEILING MOUNT INSTALLATION SHOULD ONLY BE ATTEMPTED BY TRAINED PERSONNEL AND
LOCAL BUILDING CODES MUST BE FOLLOWED IN THE INSTALLATION OF THE PROJECTOR.
At the installation site, it is always a good idea to touch up all settings to compensate for any minor variations
in projection throw distance or the projector to screen angle.
After the projector is installed you should consider whether or not the menu system should be protected.
Protecting the menu system will restrict the user’s access to the setup menus so that your calibrations will not
be disturbed. Some users, however, will insist on the ability to change the internal settings. If the settings are
NOT protected, you should be certain to explain the care with which any modifications or corrections should
be made.
When the set is installed, you should explain the basic operational controls to the user: power on/off (using
either the remote or automatic operation with source sensing), Source selection, brightness, contrast and
center convergence adjustment, and the white balance and color temperature controls.
You should also explain the functions of the LED indicator on the front panel of the HD-700 as noted at the
beginning of this manual.
