11 of 29
At this point you are ready to proceed with the initial adjustment of the unit. Make certain that the power and
signal connections have been made, and that a high quality signal feed is supplied from either a laser disc player
or a test signal generator.
NOTE: All initial adjustments will be saved in the Source memory with the preset name “LD-10”. If you
wish to save the adjustments with a different name you must first create that name memory. To create a
different name please follow the steps for “SOURCE MEMORY ENTRY” on page 20 before performing
adjustments.
Focus Adjust Menu
Turn the unit on by pressing the “
POWER
” switch and note that the green LED
on the HDP-500’s front connection
panel will illuminate.
Press the “
MENU
” button and observe that the Main Menu will appear on the screen.
-Main Menu-
1.
Brightness
2.
Contrast
3. Center Convergence
4. Centering
5. Blanking
6. Size
7. Source: LD-5 -31.468KHz-60.00Hz
8. Adjust
9. Set Up HDP-500-16-FF
If the menu is not in clear focus, adjust the optical focus on the green lens. Loosen the back wing nut and rotate
the lens barrel by holding the lens with one hand and moving the nut with the other along the track provided.
When the picture is in sharp focus hand tighten the wing nut.
To adjust the edge focus, loosen the wing nut closest to the outer edge of the lens and focus by holding the back
of the lens with one hand while you rotate the outer barrel with the other. You may find it easier to grasp the
“wings” that protrude up from the barrel to aid in the focus.
Once this initial focus has been made you may proceed with the complete focus process.
1. Press the
“MENU”
button to display the Main Menu.
2. Press the
“8”
button to display the Adjust menu.
-Adjust-
1.
Focus
2. Gray Scale
3.
Geometry
4. Convergence
