2 of 29
Table of Contents
Safety
Information ___________3
Important Information for the User___________________4
Specifications
___________5
Introduction ___________6
Pre Installation Preparations________________________7
Signal Connections___________________________________7
Front Panel Connections
__________ ______8
Preparation for Adjustment___________________________9
Remote
Control
Operation __________10
Initial Set Up and Adjustment_______________________11
Focus Adjust Menu
________________11
Geometry Adjust Menu
________________13
Convergence Adjustments
________________17
Gray Scale Adjustment
________________20
Brightness Adjustment
________________21
Contrast
Adjustment
__________21
Center
Convergence __________21
Centering
Adjustments
________________21
Blanking
Adjustments
__________22
Size
Adjustments
________________22
Source
Memory
Entry
__________22
Global
Setup
Adjustments __________23
Power On Control
________________23
Menu
Access
________________23
Menu
time-out
__________24
White Balance Control
__________24
Scan
Reversal
__________25
Screen Size Change Procedures
________________27
Service & Warranty__________________________________29
WARNING
HAZARDOUS VOLTAGE
DO NOT OPEN
ATTENTION
COURANT ELECTRIQUE
NE PAS OUYRIR
CAN SHOCK, BURN OR CAUSE SEVERE INJURY OR DEATH. DO NOT
REMOVE COVER OR BACK PANEL. REFER SERVICING TO QUALIFIED PERSONNEL.
!
.
DWIN Electronics, Inc.
5838 San Fernando Road Unit D
Glendale, CA 91202
Tel: 818-956-1608
Fax: 818-956-0721
This manual and all information pertaining to circuit
designs, internal operating software and industrial
design are Copyright © by DWIN Electronics Inc.
All Rights Reserved.
Any reproduction or distribution is strictly prohibited.
