- 16 of 23 -
Physical Mounting Instructions
Physical and electrical installation of the TransVision
™
must be performed only by a trained
professional who is knowledgeable about both the specifics of the TransVision
™
and the requirements
of the local building and electrical codes in your state.
Physical installation of the TransVision
™
may be divided into three steps:
1. Pre-installation planning, which includes plotting the projector-to-screen distance. This requires
knowledge of the screen size and placement. From this step you will determine where the projector
is located.
2. Location of the installation position and preparation, including drilling holes and assembling the
mounting hardware.
3. Installation of the ceiling mount bracket and placing the projector in the mount.
Once the physical installation is complete, the unit should be properly adjusted for focus using the lens,
for positioning using the physical adjustments made possible by the mounting hardware and for size
and centering using the electronic adjustments in the menu control system.
PRE-INSTALLATION PLANNING
Before starting the installation you will need to calculate the projector to screen distance and the ceiling
to picture-start offset. The throw distance and the precise center of the screen are then used to
determine the exact location for the physical installation of the projector.
Throw Distance
O
H
W
Screen
Off Set
Screen Width
