WHEATON® Standard Roller Apparatus
12
DWK Life Sciences | 856.825.1100 |
www.dwk.com
| P/N 50099786 Rev. 11/2021
2
INSTALLATION AND INITIAL STARTUP
Install the unit where there will be adequate room for the unit to operate. Provide enough clearance
around the unit to keep items away from the rotating belts and pulleys.
Initial Inspection
When you receive your roller apparatus, inspect it for any obvious damage that may have occurred
during shipment. If any damage is found, notify the carrier at once. Warranty information is shown in
the front of this manual. Check to confirm that there are no broken switches, displays or pulleys and
that the unit is not dented or scratched.
Input Power Requirements
This equipment is designed to operate from a nominal 100 – 240 V single-phase AC power source at
47 to 63 Hz. The line voltage / fuse label located on the rear of the control housing shows the input
voltage and fuses set for the unit at the factory.
Power Cord Set
This unit has been shipped from the factory with a power line cord that has a plug appropriate for
your area. If the wrong power cord has been shipped for your particular application, contact your
nearest DWK Life Sciences dealer for the proper cord. The Top Drive Standard Roller Apparatus has
been equipped with a 3-wire grounding type power cord. The unit is only grounded when it is plugged
into an appropriate receptacle.
DANGER!
Do not operate the unit without adequate grounding protection.
CAUTION:
Keep hands and fingers away from rotating parts of the machine. Do not remove any
safety guards or operate the machine without the safety guards.
IMPORTANT:
This apparatus was designed to run partially filled bottles for standard cell
culture applications. Consult DWK Life Sciences Technical Service staff for specific roller
apparatus needs.
