- 2 -
Safety Considerations
WARNING!
USING ANY ANTENNA NEAR POWER LINES IS DANGEROUS
Warning
: Do not use the Receive Portable Flag Antenna near overhead power lines or other electric light or
power circuits, or where it can come into contact with such circuits. When using the antenna, take extreme
care not to come into contact with such circuits, because they may cause serious injury or death.
Parts List
QTY
Description
QTY
Description
13 ft
Antenna Wire, 14 ga, Black Relaxed PVC Insulation
1
PCB, Feed Point
1
Binocular Core, Mix 73, 0.3H x 0.4W x 0.6L
1
PCB, Resistor
1
Coax Cable, RG-58AU, BNC Male Connector Installed
4
P-Clamp, Stainless Steel, 0.3125”
6
DX Engineering Hardware - includes the following:
2 - Hex Nut - Stainless Steel, 1/4-20
2 - Flat Washer - Stainless Steel, 1/4”
2 - Split Washer - Stainless Steel, 1/4”
1
Resistor, 680 ohm, 1/4 w
1
Shrink Tube with Adhesive, 3/8” OD, 1.5” Length
1
Starboard Center, Black, Drilled, 6.5” x 8” x 1/4” thick
1
Tape, Double Sided, approx. 0.3” Wide x 0.5” Long
2
DX Engineering Saddle, 1-1/2”
1
Tube, Teflon, 13 AWG, .076” ID x 1.2” long
4
Element Clamp with stud, Stainless Steel, 1/2”
4
Tube, Wire Guide, 5/16” OD x 0.17” Long
2
Fiberglass Tube, 1/2” OD, .120” wall, 4 feet long
4
U-Bolt, Stainless Steel, 1/2”, 1/4-20 x 0.5 Thread Length
1
Fiberglass Tube, 1-1/2” OD, .120” wall, 4 feet long
2
U-Bolt, Stainless Steel, 1-1/2”, 1/4-20 x 0.5 Thread Length
4
Hex Nut, Nyloc, Stainless Steel, 10-24
4
Washer, Flat, Thin, Stainless Steel, #10 x 1/2”
2 ft
Magnet Wire, Green, 28 ga, Nysol
4
Zip Tie, 11” Long
1 ft
Magnet Wire, Red, 28 ga, Nysol
1
Instruction Manual
This kit will typically take between 1 and 2 hours to build.
