XV1000 Modem User Guide
3
7. XV1000 VDSL Modem Specification
Item
Specification
Modulation
QAM
Duplexing
FDD
Data Transmission
Symmetric/Asymmetric
Speed (DSLAM-Modem)
Downstream: max 10 Mbps, Upstream: max 10 Mbps
Standards
ANSI T1E1.4, VDSL Coalition, FSAN
Ethernet Port
: RJ-45 (10/100Base-T)
POTS Line
: RJ-11
VDSL Line
: RJ-11
Interface
Console Port
: RJ-11
Error detection
Reed-Soloman
Size
152 (w) x 172(d) x 32(h) (unit: mm)
Input
: AC 110/220V
Frequency
: 50/60 Hz
Power
Output
: 5V DC
Chapter 2. Before Installation
Explained in this chapter are issues that users should take note of before installing the modem.
This chapter includes the following sections:
l
Safety Check
l
Before installation
l
Preparing cables
1. Safety Check
The following items should be checked before the installation and use of the modem.
Electrical safety
l
Customers shall not disassemble the unit in any case, especially when the power is being applied.
l
Ensure that there are no such matters that may pose danger to the installer in the installation area:
wet floor, ungrounded cable, worn-out power cords, floor without proper ground.
l
“ This equipment does not directly connected to ISDN/PSTN line”
l
“ This equipment should be connected to XV2000 only.”
Site of Installation
l
During the operation of electrical devices, heat is inevitable. Ensure that the device is installed in such
an environment that proper ventilation will be able to dissipate heat, otherwise the device may not
function properly.
2. Telephone Network Service/PC Specification
Telephone Network Service
XV1000 VDSL modem is to be used in areas where telephone network service is provided.
Users already subscribed to the telephone service can use the telephone line as it is. New users need
to ask the regional telephone company for the telephone service and should have lines installed.
PC Specification
To connect XV1000 to the PC, a LAN card (10Base-t or 10/100Base-T) must be installed inside the PC.
