52
52
If the toilet has been used for a long period of time and flushing or cleansing functions seem to be getting weak, clean
the filters as described in the following procedure. Generally, the filters should be cleaned once every two years.
Cleaning the Filter
1 Close the water shutoff valve.
2 Press the Flush/Full or the flush buttons
on the seat unit.
* Wait for about 20 seconds before performing the next step.
3
Disconnect the power plug from the outlet.
4 Remove the side cover on the left side of
the seat unit. (Page 51)
5 Place a piece of cloth under the filter on
the left side of the seat unit and remove
the filter to drain the seat unit.
6 Thoroughly wash each component in
water to remove grime.
7 Fully reattach the filter as shown in the
diagram.
8 Attach the side cover. (Page 51)
9 Connect the power plug to the outlet.
10 Open the water shutoff valve fully.
• When using the toilet again
Be sure to perform usage checks before use. (Page 14)
[Note]
• Be careful not to damage the water supply hose when removing the filter.
CAUTION
CAUTION
•
Close the water shutoff valve when removing the filter.
•
When installing the filter, tighten it fully so there is no gap.
•
Check that the O-ring is free from foreign materials before attaching the filter, as failure to
do so could result in water leakage and flooding.
止水栓開.eps
1
2
2
1
1
2
Low Water Pressure
