54
54
Periods of Non-use
In the following cases, be sure to drain the toilet according to the procedures below and
disconnect the power plug from the outlet.
●
When the toilet is not used for extended periods of time, such as when you are away, as the water could become dirty and cause clogging.
●
If the toilet is installed in a vacation home that is not being used, drain the water from the toilet. The
temperature in an empty house can drop lower than expected, causing the water in the toilet to freeze.
Draining the Toilet
1 Close the water shutoff valve.
2 Press the STOP button or the flush
button on the seat unit.
* Wait for about 20 seconds before performing the next step.
3 Remove the side cover on the left side of
the seat unit. (Page 50)
4 Place a piece of cloth under the filter on
the left side of the seat unit and remove
the filter by turning it clockwise to drain
the seat unit.
[Note]
• Be careful not to damage the water supply hose
when removing the filter.
5
Press the Auto Clean [A] and Power save [B]
buttons simultaneously for 2 seconds.
* Drain water remaining in the seat unit for
approximately 15 seconds.
6 Thoroughly wash the filter and O-ring in
water to remove grime.
7 Fully reattach the filter by turning it
counterclockwise as shown in the diagram.
8 Attach the side cover. (Page 51)
9 Check that no water leaks from the water
shutoff valve.
10
Disconnect the power plug from the outlet.
•
When water may freeze
●
Use a container or pump to remove the water in the toilet bowl and pour antifreeze into the bowl.
* If water is simply removed, sewer gas will be emitted from the drain pipe.
•
When using the toilet again
Be sure to perform usage checks before use. (Page 14)
止水栓開.eps
1
2
2
1
1
2
[A]
[B]
