- 4 -
M965533 Rev. 1.6 (1/18)
3
INSTALL VALVE BODIES and HANDLES
• Thread LOCKNUT
(1)
to bottom of VALVE BODY
(2)
. Make sure SPACER
(3)
, BRASS WASHER
(4)
and RUBBER WASHER
(5)
are installed.
• Insert VALVE BODY
(2)
through mounting hole from underside of tub deck or mounting surface.
Note: VALVE BODY marked Hot (Red Dot) is installed in the left Mtg. hole, VALVE BODY marked Cold (Blue Dot)
in the right when facing front of fitting. Maximum mounting surface thickness is 1-3/4".
• Install STOP RING
(6)
onto VALVE BODY
(2)
. Thread FLANGE
(7)
onto VALVE BODY
(2)
until tight aganist the STOP RING
(6)
.
• Align VALVE BODY
(2)
and from below tighten LOCKNUT
(1)
to secure VALVE BODY
(2)
.
INSTALL HANDLES:
• Install SEAL
(8)
into base of HANDLE ESCUTCHEON
(9)
. Turn VALVES to off position.
• Align HANDLE ASSEMBLY
(10)
and push down onto spline of VALVE BODY
(2)
. Thread HANDLE ESCUTCHEON
(9)
tight against mounting surface. Installation for the Cold Water Valve is the same.
• All HANDLE ASSEMBLIES install in the same way.
HOSE CONNECTIONS:
• Tighten COUPLING NUT
(11)
on SUPPLY HOSE
(12)
to OUTLET
(13)
making a water tight connection.
• Tighten other end of SUPPLY HOSE
(12)
to HOT side of DIVERTER VALVE
(14)
.
• Connect the COLD water SUPPLY HOSE
(15)
to OUTLET
(16)
and to the cold side of DIVERTER VALVE
(14)
.
COLD
COLD
14
SPLINE
RED DOT
STOP RING
SEAL
1
HOT
HOT
BLUE
DOT
13
SEAL
5
11
3
4
2
7
8
6
9
10
1-3/4'' (44 mm) MAX.
MOUNTING SURFACE
HANDLE ASSEMBLIES
CROSS
HANDLE
CYLINDER
HANDLE
12
15
16
TRI-SPOKE
HANDLE
ASSEMBLY
