- 5 -
M965533 Rev. 1.6 (1/18)
4
4a
MAKE WATER SUPPLY CONNECTIONS
TEST INSTALLED FAUCET
• Connect HOT water supply to LEFT INLET UNION
(1)
and COLD water supply to RIGHT INLET UNION
(2)
.
Pipe connections are 3/4" (19 mm) NPT. Use sealant or Teflon tape on pipe connections.
Do not solder directly to valve body.
• Remove AERATOR from FAUCET.
• With HANDLES in OFF position, turn on WATER SUPPLIES and check all connections for leaks.
• Operate both HANDLES to flush water lines thoroughly.
• Replace AERATOR.
• Lift HAND SHOWER from HOLDER, direct spray into tub. Lift TRANSFER KNOB to check HAND SHOWER
and HOSES for leaks.
• Turn handles “off” and replace HAND SHOWER.
3/4" X 3/4" NPT UNION
(NOT SUPPLIED) (19 mm X 19 mm)
HOT
COLD
3/4" NPT (19 mm)
AERATOR
TRANSFER
KNOB
3/4" NPT
(19 mm)
2
1
IMPORTANT: It is strongly recommended that
access be provided for all enclosed mechanical
parts to this system.
HAND SHOWER
