- 6 -
M965560 Rev. 1.3 (5/17)
• Disconnect the Cable from the Drain by threading the Cable Connector
(1)
counter-clockwise.
Fig. A.
• Look at the area on the Drain Body where the Cable was attached and locate the component labeled as
“Cam” in the illustration.
Fig. B.
• Use a small screwdriver to rotate the Cam in the clockwise direction as far as it will go. At this point the
Stopper should be in the UP position.
Fig. B, C.
• Push DOWN on the Lift-Knob to make sure it is fully down.
Fig. C.
• Re-attach the Cable to the Drain Body Connection
(2)
by threading the Cable Connector
(1)
clockwise onto the
Drain Body Connection
(2)
and hand-tighten.
Fig. A.
• Disconnect the Cable from the Drain by threading the Cable Connector
(1)
counter-clockwise.
Fig. A.
• Look at the area on the Drain Body where the Cable was attached and locate the component labeled
as “Cam” and “Cam Cap” in the illustration.
Fig. B.
• Use fingers or small screwdriver under either side of the Cam Cap to pry it out from the Drain.
Fig. D.
• Remove the Cam by pulling it straight out while wiggling gently to loosen the Rubber Seal.
Fig. E.
• The Stopper can now be removed by lifting it out of the Drain.
Fig. F.
If sink does not hold water even though Stopper is in the “down” position:
• Follow CABLE ADJUSTMENT PROCEDURE.
If Stopper does not raise up fully or sink drains too slowly:
• Follow CABLE ADJUSTMENT PROCEDURE.
If you need to remove the Stopper:
• Follow STOPPER REMOVAL PROCEDURE.
If you would like the ability to remove your Stopper simply by lifting it out of the drain:
• Follow STOPPER INSTALLATION PROCEDURE for
“Unlocked” mode
.
CABLE ADJUSTMENT PROCEDURE
STOPPER REMOVAL PROCEDURE
Speed Connect
®
Drain
Troubleshooting Guide
REMOVE
CAM
Fig.
E.
Fig.
F.
Fig.
D.
REMOVE
CAM CAP
CAM
CAM CAP
Fig.
B.
Fig.
A.
2
1
RE-ATTACH
DISCONNECT
Fig.
C.
DOWN
STOPPER
REMOVE
CAM
Fig.
E.
Fig.
F.
Fig.
D.
REMOVE
CAM CAP
CAM
CAM CAP
Fig.
B.
Fig.
A.
2
1
RE-ATTACH
DISCONNECT
Fig.
C.
DOWN
STOPPER
