Customer Service 1-888-707-1880
Dyaco Canada Inc. 2016
Email: customerservice@dyaco.ca
19
PROGRAMMABLE
FEATURES
SELECTING A PROGRAM
The treadmill offers nine factory preset-programs, two user defined programs and one Manual
program. Each preset program has a maximum speed level that is displayed when a desired
workout is chosen. The maximum speed that the particular program will achieve will be
displayed in the Speed window.
Also included are two user programs (
User 1
and
User 2
) for custom workouts.
1. Press the desired
Program (Hill, Fat burn, Cardio, Strength Interval, Calories, and
Fusion
) key. Press
Enter
to select the program. The display will prompt you through the
programming or you can just press
Start
to begin the program with default values.
2. If
Enter
was pressed, the
Message center
will now be blinking a value, indicating your
Age
(default is 35). Entering your correct age affects the heart rate Bar Graph Display and the
Heart Rate programs. Use the
+ or
– keys
to adjust, then press
Enter
. Your age determines
your recommended maximum heart rate. Since the Bar Graph Display and the Heart Rate
features are based on a percentage of your maximum heart rate, it is important to enter the
correct age for these features to work properly.
3. The Message center will now be blinking a value, indicating your
Body Weight
(default is
150 lbs/70kgs.). Entering the correct body weight will affect the calorie count. Use the
+ or
–
keys
to adjust, then press
Enter
.
A note about the Calorie display:
No exercise machine can give you an exact calorie count because there are
too many factors which determine exact calorie burn for a particular person. Even if someone is the exact
same body weight, age and height, their calorie burn may be very different than yours. The Calorie display is to
be used as a reference only to monitor improvement from workout to workout.
4. The Message Center will be blinking a value, indicating
Time
(the default value is 30
minutes). You may use any of the + or - keys to adjust the time. After adjusting, or to
accept the default, press
Enter
.
(
Note
: You may press start at any time during the programming to start the program).
5. The Message Center will now be blinking the preset top speed of the selected program (3
MPH or 5 KPH). Use the
Speed + or
– keys
to adjust, then press
Enter
. Each program has
various speed changes throughout; this allows you to limit the highest speed the program
can reach.
6. The Message Center will be blinking the preset top incline of the selected program. Use the
I / - keys
to adjust, then press
Enter
.
You are now done programming data and
may press
Start
to begin your workout or
Stop
to go back one level to change data entered
in the programming phase.
CUSTOM USER DEFINED PROGRAMS
1. Press the
User 1-2 key
once for
User 1
or twice for
User 2
then press
Enter
. Note that the
dot matrix display portion will have a single row of segments at the bottom (Unless there is
a previously stored program).
2. If there is a program stored under the button that is pressed, it will be retrieved. If not, you
have the option of programming in your first name. The message window will display and
flash the let
ter “A”. To change it, press the
Speed
+ key, then “B” will be displayed; if the
