Dyconn RAID Vault 2, Manual

5

INSTALLATION of hard drive

RAID SWICH SETTING LIST

Item  S/W 1  S/W 2  RAID MODE  Description
  1  OFF  OFF  Normal 

Normal , works as 2 individual HDD’s

  2  OFF  ON  JBOD 

JBOD, works a 1 single HDD

    3 

ON  OFF  RAID0 

RAID0, works as 1 single HDD

    4 

ON 

ON  RAID1 

RAID1, works as 1 single HDD

The setting of RAID mode

Hard disk combined mode can be set by setting the MODE jumper switches on 

the rear panel of the enclosure.  

RAID mode change procedure

Before using this product, please back up your original data in the hard drives,  

as the data in the hard drives might be lost during the RAID mode setting. Please 

refer to the above RAID SWITCH SWETTING LIST to do the mode setting; and 

follow the below procedures to set the jumper switches:

Setting new mode, pls. follow the mode list as below, press the Rest button for 

8sec after turn on the power,

WARNINGS:

Please backup the data in your hard disk before setting any RAID at the 

beginning, as the RAID mode setting procedure will initialize the hard drive(s) 

into the virtual disk volumes and completely remove the original data from the 

hard drive(s) first.