BlueWave® MX-250 Emitter User Guide
9
Troubleshooting & Maintenance
Problem
Possible Cause
Corrective Action
BlueWave® MX-250
LED does not
produce light
LED intensity adjustment
set to 0% or too low
Increase LED intensity setting.
LED cycle time is set to 0
seconds
0 Seconds sets manual mode and
requires a trigger.
Interlock is open
Verify interlock jumpers are in place.
Verify PLC command structure for PLC
mode.
Interface cable connections
loose or damaged
Check connections and condition of
interface cable.
Trigger setting not
matched to input
Trigger setting on admin screen should
match the desired input trigger
channel.
LED head is not connected
to the correct port/channel
Verify that the head is connected to the
desired port/channel.
BlueWave® MX-250
LED suddenly stops
producing light
Over-temperature
shutdown was triggered
Verify alarms.
Footswitch defective
Activate unit using the front control
panel. Replace the footswitch if the unit
operates from the front control panel.
Interlock is open
Verify interlock jumpers are in place.
Verify PLC command structure for PLC
mode.
BlueWave® MX-250
LED provides only
low-intensity light
LED intensity adjustment
set to minimum
Increase LED intensity setting on admin
settings or I/O input for PLC mode.
Contaminated/dirty lens
optics
Clean the surface of the lens.
