7
Cleaning
•
Clean the cutter blade regularly: Press and hold down
cutter lever
E
to expose cutter blade
D
➊
, then use a
cotton bud and alcohol to clean both sides of the blade.
Release cutter lever
E
.
•
Check and clean print head face
D
➋
regularly using a
cotton bud and alcohol ONLY.
Troubleshooting
No display
•
check machine is on
•
replace discharged batteries
•
check AC adaptor.
No printing or poor text
•
replace discharged batteries
•
check tape cassette installed correctly
•
clean the print head
•
replace the tape cassette.
Poor print quality with white ink
•
When using a White on Black or a White on Clear
cassette, it may be necessary to use the darkest
contrast setting in order to obtain good print quality.
To change the contrast setting via the keyboard, read
and follow the instructions as described in the
paragraph “Print Contrast”.
Tape jammed
•
lift out tape cassette carefully
•
remove/release jammed tape
•
DO NOT cut the ink ribbon – turn spool
C
➌
to tighten
•
cut off excess label tape
•
refit/replace the tape cassette.
Poor cutter performance
•
clean the cutter blade regularly
example:
A1
with a line of symbols above
it. Each letter selects a line of symbol characters,
numbered 1 to 6, as shown in the table on page 2.
•
Press
DEL
to cancel, or
•
Press a letter key ‘A’ to ‘Z’ until you find the line of
symbols required. You can then press a number key ‘1’
to ‘6’ to select the symbol required.
Alternatively, use
or
to step through the rows A
to Z, then use or to move the cursor under the
symbol required.
Press
to place the symbol in the label.
PRINT CONTRAST
— may be adjusted by pressing
+
SYMBOLS
followed by
to display the contrast
symbols
.
•
Use or to select lighter or darker print.
•
Press to confirm the setting. The contrast level will
revert to the mid-setting when the LabelManager is
turned off and on again.
Note: This function enables you to adjust the print
quality under extreme temperature conditions.
No response to print key
•
!!!!!!!!!!!!!!!
in the display indicates a printer jam.
Press any key to return to normal display. Open the
cassette compartment and free the jam.
•
flashing in the display
indicates discharged batteries. Press any key to return
to normal display. Replace the batteries.
No success?
•
Call the DYMO customer service hotline telephone
number for your country – see the warranty booklet.
Summary of Contents for DYMOLM200
Page 6: ... Esselte Dymo 2000 Written by DAW Publications Cambridge ...
Page 12: ...8 ...
