6
ASSEMBLY INSTRUCTIONS
Hardware Used
2
3
2. Loosely attach three support brackets (F) to base (G)
with three bolts M8 x 16 (BB) downward through support
brackets (F) into the base (G).
3. Install post (E) onto three support brackets (F). Attach
post (E) to support brackets (F) using six bolts
M6 X 30 (EE) & six M6 flange nuts (CC). Fully tighten all
of the screws, including those at the base (G).
BB
LL
Bolt M8 x 16
x 3
CC
x 6
M6 Flange nut
EE
Bolt M6 x 30
x 6
Hardware Used
BB
EE
CC
x 1
Wrench
LL
x 1
Wrench
LL
x 1
Wrench
F
G
E
F
Hardware Used
AA
BB
1
1. To improve the stability, the base (G) must be filled with sand.
Remove lid from center of base (G). Slowly pour the sand into
the base (G). Shake the base to disperse the sand evenly.
Close lid tightly.
Attach wheel assembly (H) to base (G). Line up holes in wheel
bracket (H) with corresponding holes in base. Insert two
bolts M8 x 16 (BB) through holes, and finger tighten two M8
flange nuts (AA). Be sure that the wheel assembly (H) is parallel
to the base (G), and fully tighten bolts.
x 2
Bolt M8 x 16
M8 Flange nut
x 2
G
AA
BB
H
Fill sand
