INSTRUCTION USER MANUAL & WARRANTY
3
Thank you & Congratulations on the purchase of
your Dynabreeze 350mm Low Pressure Misting Ring
PARTS IDENTIFICATION
ASSEMBLY & OPERATION
1. Remove all contents from the box and
check all parts are included.
2. Insert the combined pipe and filter into the
t-junction centre piece.
3. Secure the misting ring centrally onto the
face of the fan using the supplied cable
ties and trim off any excess. Ensure the 3
nozzles are facing straight out.
4. Connect the hose connection to the (off)
water supply and turn on the fan.
5. Once the fan is on, the water supply can be
turned on. Ensure that any wind is behind
the fan.
6. To turn off the mist, first turn off the water
supply and then turn off the fan to ensure
water does not spray onto the fan motor.
NOTE:
If the nozzle drips a few actions can
be taken such as tightening the nozzle as
much as possible or increase the water flow.
Low Pressure Nozzle
T Junction
Centre Piece
1.5m Connection
Pipe
Filter
Snap Fit Hose
Connection
Transfer Male
Connecter
Slip Lock Connecter
O-Ring
Clamps
Internal
Claws
