DYNACO Dyna Stereo 70, Installation Instructions Manual

2 

The following steps require the use of a soldering iron. In the following steps, disconnect the 
wires at the PCB end only, after unsoldering, bend wires away from PCB to avoid burning the 
wire insulation with soldering iron. Avoid sharp bends to prevent breaking wire. (If wires appear to 
be brittle, it is highly recommended that they be replaced with pre-tinned #20-#22AWG stranded 
wire). 

 
(   ) Using a soldering iron, disconnect wire connected to eyelet #11 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #12 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #13 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #14 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #6 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #7 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #1 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #2 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #5 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #4 on PCB. 
 
(   ) Using a soldering iron, disconnect 10 ohm (brown, black, black) resistor 
 connected to eyelet #8 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #3 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #19 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #20 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #21 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #15 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #16 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #9 on PCB. 
 
(   ) Using a soldering iron, disconnect 10 ohm (brown, black, black) resistor 
      connected to eyelet #10 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #17 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #22 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #23 on PCB. 
 
(   ) Using a soldering iron, disconnect wire connected to eyelet #18 on PCB. 
 
(   ) Using a pair of wire cutters/ strippers, disconnect two (2) remaining wires connected to PCB, 
cut wires as close to the PCB as possible (these wires will be reconnected to the new PCB).