25
MAINTAINING YOUR RIDE-ON TOY
Occasionally use a lightweight oil to lubricate moving parts such as wheels and the
steering linkages.
Park the ride-on toy indoors or cover it with a tarp to protect it from wet weather.
Keep the ride-on toy away from sources of heat, such as stoves and heaters.
Plastic parts may melt.
ADULTS ONLY:
Recharge the battery after each use. Recharge the battery at least
once a month when the ride-on toy is not being used.
DO NOT
wash the ride-on toy with a hose.
DO NOT
wash the ride-on toy with soap
and water.
DO NOT
drive the ride-on toy in rainy or snowy weather. Water will damage the
motor, electrical system, and battery.
DO NOT
store the ride-on toy, outside in the rain or exposed to the elements. The
ride-on toy should be stored inside or covered to protect it from exposure to the
elements.
Clean the ride-on toy with a soft, dry cloth. To restore shine to plastic parts, use
a non wax furniture polish.
DO NOT
use car wax.
DO NOT
use abrasive cleaners, or
cleaners that contain ammonia or isopropyl alcohol.
DO NOT
drive the ride-on toy in loose dirt, sand or fine gravel, which could damage
moving parts, motors or the electric system.
WARNING:
Charge the battery before storing your ride-on toy, otherwise the
battery will be damaged.
ABOUT FUSES
Your ride-on toy is equipped with a safety thermal fuse. The fuse is a self-resetting
safety device which automatically “trips” and shuts down operation of the ride-on
toy if the ride-on toy is overloaded or the operating conditions are too severe. Once
a fuse has “tripped,”
do not continuously push on the foot pedal
. The fuse will
automatically reset itself after approximately 2 minutes and allow the ride-on toy
to resume normal operations. To avoid repeated automatic shut-downs, do not
overload the ride-on toy by exceeding the 130 Ib (59 kg) maximum weight capacity
or by towing anything behind the ride-on toy. Avoid severe driving conditions, such
as driving up slopes or running into fixed objects, which can cause the wheels to
stop spinning while power is still being supplied to the motor.
