11
12
STEERING WHEEL BATTERY SAFETY INFORMATION:
Batteries may leak fluids that can cause chemical burn, injury or ruin your product.
To avoid battery leakage:
• Install batteries correctly, observing the polarity (+,-) signs to avoid leakage.
• Do not mix old and new batteries.
• Do not mix batteries of different types: alkaline, standard (carbon-zinc) or
rechargeable (NiMH).
• Remove the batteries from the battery compartment when the unit will not be
used for an extended period of time.
• Always remove exhausted batteries from the battery compartment.
• Do not dispose of batteries in fire.
• Do not short circuit the supply terminals.
• Replace the batteries when the horn sounds become distorted.
• Non-rechargeable batteries should not be recharged.
• Use only batteries of the same or equivalent type as recommended.
• If rechargeable batteries are used, they should only be charged by an adult.
• Remove rechargeable batteries from the product before charging.
• Battery chargers used with toys must be examined regularly for damage to the
cord, plug, enclosure and other parts. In the event that such damage is found,
the toy must not be used with the battery charger until the damage has been
repaired.
6. ROOF ASSEMBLY
• Find the roof and two U shape supports
as shown.
• The U shaped supports are marked
with either an “L” or “R”. Find the
corresponding “L” and “R” markings on
the roof panel and then fit each U shaped
support to the corresponding spot on the
roof panel as shown in the diagram to the
right.
• Secure the U shaped supports to the roof
using 3 4x16 mm flat head screws on each
support, as shown in the diagram at right.
7. ROOF FRONT SUPPORTS
ASSEMBLY
• Find one Front Support marked with an
“R” and attach it to the corresponding U
shaped support also marked with an “R”.
Use two 4x12mm Round head screws to
secure the supports, as shown at right.
• Find the other Front Support, marked with
an “L” and attach it to the corresponding
U shaped support also marked with an “L”.
Use two 4x12mm Round head screws to
secure the supports, as shown at right.
4x16 Flat Head
Screw
5. STEERING WHEEL BATTERIES
INSTALLATION
NOTE:
Batteries are not included.
• Unscrew the screw in the steering wheel and
remove the cover.
• Insert 2x1.5V size AA AM-3 or LR6
batteries.
• Replace the cover and tighten the screw
to secure it in place.
Battery Compartment
Cover
4x12 Round
Head Screw
4x12 Round
Head Screw
“R” Mark
“L” Mark
Front
Supports
4. STEERING WHEEL ASSEMBLY
• Gently turn the vehicle body upright.
• Remove the M5x35 machine screw and
nut from the steering wheel.
• Insert the steering wheel onto the end of
the steering column, line up the hole in the
steering wheel and the hole in the steering
column, reinsert the M5x35 machine
screw as shown, and tighten it with M5 nut
securely.
Steering
Wheel
Screwdriver
M5x35
Machine
Screw
M5 Nut
U Shape
Support
"L"
"R"
DC 1.5V (SIZE AA)
DC 1.5V (SIZE AA)
-
+
-
+
