9
2. Driving Wheel Assembly
. Turn the vehicle body upside down.
3. Front Axle Assembly
. Turn the vehicle body upside down.
. Fit the front axle assembly to the
vehicle body as shown. Then use a
screwdriver to tighten four 4x12
round head screws on each side to
. Slide the gear box through the axle
into the vehicle body, make sure the
motor and motor power wire are
inserted into the vehicle body.
Note:
Note:
The gear box shall be installed
onto the Right side of vehicle
(riding position).
. Slide the driving wheel onto the axle
and make it match up with the gear box.
.
e
l
x
a
e
h
t
o
t
n
o
r
e
h
s
a
w
e a
Ø12
d
il
S
.
. Install the M10 locknut and tighten it.
. Fasten the axle cap.
To asse
,
e
d
i
s
r
e
h
t
o
e
h
t
n
o
l
e
e
h
w
r
a
e
r
e
h
t
e
l
b
m
refer to the front
wheel assembly information at page 10.
secure the front axle assembly.
4. Front Wheel Assembly
Ø
Ø
. Turn the vehicle body upside down.
. Remove all parts from front axle.
s
a
w
2
1
t a
i
F
.
her onto the axle.
. Fit a bushing onto the axle.
. Slide a wheel onto the axle, make the
bushing match inside the wheel.
. Install a
tighten it. (Note: Do not over-tighten)
12 washer and locknut, then
. Fasten the axle cap.
. Repeat above operation for the front wheel on the other side.
