In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
C H A P T E R 1
Introduction
1-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INTRODUCTION
Before installing your dyno, please take a moment to read this guide for installation
instructions, dyno features, and other important information.
This guide is designed to be a reference tool in your everyday work and includes the
following chapters and information:
S
PECIFICATIONS
AND
O
PERATING
R
EQUIREMENTS
This chapter describes the requirements and specifications for the dyno.
I
NSTALLATION
This chapter describes the procedures for installing the dyno.
A
CCESSORIES
This chapter lists each dyno accessory alphabetically and describes the procedures for
installing and using the accessory.
C
ONTROL
P
ANEL
I
NTERFACE
O
PERATION
This chapter describes the Control Panel Interface (CPI) operating procedures.
B
ASIC
D
YNO
O
PERATION
This chapter describes basic dyno operating procedures.
R
ED
H
EAD
I
NSTALLATION
This appendix describes the procedures for installing the Red Head anchors.
P
OWER
R
EQUIREMENTS
This appendix describes the power requirements and installation instructions for all
locations excluding North America.
EEC F
INGER
G
UARD
& D
OOR
S
AFETY
S
WITCH
K
IT
This appendix describes the procedures for installing the EEC finger guards and door
safety switch.
T
HETA
C
ONTROLLER
This appendix describes how to make power adjustments to the theta controller.
