Operation
6 — 1
APS05_011_0404GB
6
Operation
This chapter contains information on machine operation. You will
learn what operations are required for setting up the machine,
operation and for cleaning.
Do not direct the cleaning jet vertically onto the surfaces to be
cleaned. Try to "peel off" the dirt layer from the surfaces.
The setting values depend on the tasks to be carried out.
For cleaning work, proceed as follows:
"
Start the engine as described in the section "Starting up".
Caution
The pressure side must be fully open when the drive motor is
started, i.e. press the spray gun trigger.
This optimises the quick−fill feature on the pump and avoids dry runs.
"
Depending on weather conditions, run the engine for a few
minutes until it reaches its working temperature.
Danger
Observe the maximum operating pressure of the spray gun used.
The maximum operating pressure should not be exceeded.
Continuation next side
Tip for cleaning
surfaces
6.1
Setting
6.2
High-pressure clea-
ning
