Pilot Operating Handbook
H3 Sport 135 HP
SECTION 4
NORMAL PROC.
Dynali_POH_H3 Sport 135 HP Rev. 3.3 – Issue date 15.01.2021 Page
42
CAUTION
Drive belts must be tensioned to the recommended value. In case of doubt,
see the maintenance manual for adjusting the tension of the belts.
If they are too loose, belt slipping may be noticed during flight.
NOTE
After the first hours of use of the belts (following delivery or after
maintenance replacement), the tension should be re-adjusted.
Ø
Check that the belt guides are parallel to the belts.
Ø
Check the shaft bearing.
Ø
No deformation of the rubber coupling attachment (the main transmission shaft
has not moved to the rear).
Ø
Check the absence of leak on the freewheel.
Ø
Check the tightening rings (pulley and shaft bearing).
Ø
Check the water level in the water expansion tank.
Station 4 (stabiliser)
Ø
Check the attachment of the tail tube.
Station 5 (tail rotor)
Ø
Check for leaks and oil level in the Rear Transmission Gearbox.
Ø
Check the Telatemp.
Ø
Check appearance of tail rotor blades.
Ø
Test the full pitch on rotor blades.
Ø
Test the full travel of the rear rotor control cables.
Ø
Check the six studs and their locking wire.
Ø
Check the attachment of the cable bracket.
Ø
Check the lubrication.
Summary of Contents for H3 Sport 135 HP
Page 85: ......