A 1012 Dynalink Learning Universal Remote Control
4
D. Set up by Learning
The LEARN function is used to either program codes from a remote control not in the pre-
programmed codes list, or to supplement the preprogrammed codes. In learn mode, you
need the original device remote control to learn the codes. Please use fresh batteries for
both the learning remote control and the original.
To learn place the remote controls next to each other as shown below. In learning mode the
remotes must not be more than 30 mm apart, with the remotes in a straight line. The receiver
LED on the A 1012 for learning is next to the transmitter LED.
1.
To learn, press and hold the Learn key and press the A 1012 device type button
that you want to learn (e.g. DVD), then release both pressed keys. The DVD
device button on your new remote control blinks and the A 1012 remote control is
now in learning mode for DVD codes.
2.
Press and release the A1012 remote button that you want to learn to
(e.g.POWER). The device button now illuminates continuously.
3.
Press and hold the source button on your original remote control (e.g.POWER)
until the LED on your new remote control blinks 2 times and illuminates
continuously for 2 seconds, then blinks again. (This means you have learnt the
POWER signal from the original remote. You’re A 1012 remote control is now
ready to learn the next button
4.
Repeat steps 2 to 4 to learn all required buttons.
If there is a learning problem, the light blinks 4 times and lights up for 2 seconds then blinks.
Repeat learning steps again to learn the required button. When learning is finished, to exit
the learning mode, press and release LEARN key.
Note 1.
The remote will exit learning mode if no key press for 30 seconds .
Note 2.
You can press SET and 4 together to delete all buttons you have learnt under a
device button. Ensure you select the device button first. The device LED will flash 2 times to
confirm.
Note 3.
If the remote controls memory is full, the LED will blink 4 times then exit learning.
Note 4.
The last learnt signal will overwrite the previous signal stored in that device and
button. About 100 commands can be stored in this remote control and about 40 commands
can be learnt for one device.
Other Functions
A. Display the Device Code:
The device code, which has been set up in your new remote control, can be called up
as follows:
1.
Press the SET key and hold it down. Now actuate number “1” key to display
the 100th position of the 3-digit code. Count the number of times the LED
flashes. If the LED doesn’t flash, that means the digit is ZERO.
2.
Similarly, press the SET key and hold it down, at the same time actuate the
number “2” key to display the 10
th
position of the 3-digit code. Count the
number of times the LED flashes.
3.
Press the SET key and hold it down, at the same time actuate number key “3”
to display the 1
st
position of 3-digit code. Again count the number of times the
LED flashes.
For Example, for Code 028:
a. Press SET and “1”, LED flashes 0 times, no flashes.
b. Press SET and “2”, LED flashes 2 times.
c. Press SET and “3”, LED flashes 8 times.