Page 3
2280-TJ80 MANUAL - FORM 2280TJ-001
MODEL 2280-TJ80 SINGLE/INSWING
ELECTROMAGNETIC LOCK
INSTALLATION INSTRUCTIONS
4/07
705 Emmett Street Bristol, CT 06010
1-877-DynaLock www.dynalock.com
MOUNTING CONSIDERATIONS
Individual door and frame
conditions may vary. Dimensions
shown at right are for a typical
hollow metal door and frame.
The Lock Assembly should be
mounted closest to the strike
jamb of the frame for maximum
performance. Verify that there
is proper clearance for the
lock assembly at the planned
mounting location.
1.
2.
INSTALL THE LOCK MOUNTING BRACKET
Separate the Lock Mounting Bracket from the Lock Assembly (see
page 6). Standing at the “pull” side of the door, place the Lock
Mounting Bracket on the face of the frame header as shown below.
Using the Template Drawing, locate and mark the centers of the two
slotted mounting holes and the wiring hole.
Drill the marked holes in the face of the frame header:
a. two 1/8” holes for #10x1” sheet metal screws or drill
and tap for 10-24x1/2” machine screws
b. one 5/8” hole for wiring
Attach the Lock Mounting Bracket to the frame header. Tighten the
screws just enough to allow for nal adjustment.
1.
2.
3.
LEFT HAND DOOR
RIGHT HAND DOOR
FLUSH WITH FRAME RABBET
SLOTTED MOUNTING HOLES
1/8” TYP
WIRING HOLE
HINGE SIDE
OF DOOR
HINGE SIDE
OF DOOR
