Leaders in Pipelin
e Survey Systems
C
C
C
-
-
-
S
S
S
C
C
C
A
A
A
N
N
N
2
2
2
0
0
0
1
1
1
0
0
0
SYSTEM MANUAL Version 6.03i
1
C-SCAN SURVEY MANUAL
PREFACE
This manual explains the operation of the C-SCAN System for surveying the condition of
the wrap or coating on buried metal pipelines, and locating faults in the wrap. It is
intended for the use of surveyors with some experience of the survey and maintenance
of pipelines
While the C-SCAN equipment is reasonably robust and weatherproof, it contains delicate
electronic components and should be handled with appropriate care and it should be
transported in its specially designed soft cases or otherwise protected from major
shocks. The C-SCAN Detector Unit can also be damaged by exposure to some forms of
radiation and to static electricity. Maintenance of this equipment should only be carried
out by qualified personnel.
The material contained in this Manual is copyrighted by Dynalog Electronics Ltd, and is
not to be photocopied, duplicated, or reproduced in any form without the express
written consent of Dynalog Electronics Ltd.
Publication in this manual of information on the design and operation of the C-SCAN
System does not confer any rights to use this information other than for the purpose of
operating C-SCAN equipment supplied by Dynalog Electronics Ltd.
Dynalog reserves the right to make improvements in its products without incurring any
obligation to incorporate such improvements into products already sold.
Specifications, instructions, and other information contained in this Manual are subject
to change without notice.
Before any setup work or survey work is undertaken, these instructions must be read and
fully understood by the operators who will carry out the survey work using this
equipment.
Any comments, queries or suggestions concerning this manual
should be sent to :
Dynalog Electronics Limited
PO Box 1073 | Bristol | BS15 0DW | United Kingdom
E&OE
For firmware versions 4.10 or higher
United Kingdom Health & Safety at Work Act 1974
Section 6 (a) of this Act requires manufacturers to advise their customers
on the safety and handling precautions to be observed when installing, operating,
maintaining and servicing their products.
The user’s attention is therefore drawn to the following:
1. The appropriate sections of this manual must be read carefully before using the equipment.
2. Operation and maintenance must only be carried out by suitably trained personnel.
3. Normal safety precautions must be taken and appropriate procedures observed to avoid accidents
Refer to the equipment suppliers — name and address below — for any technical advice or
product information
