10
CONTINUED: NXT BACK INSTALLATION INSTRUCTIONS
TO LOCK LATCH MOVE THIS
SCREW TO THE ADJACENT
HOLE, THIS WILL PREVENT
THE LATCH FROM LIFTING.
REPLACE SCREW FOR
NORMAL OPERATION.
NOTE: EXTRA HOLE IS NOT
THREADED BUT THE SCREW
WILL MAKE ITS OWN THREAD.
9.
Make sure that the overall fit and alignment of the back is correct, if not
make adjustments as required.
10.
Secure the cane clamp screws onto each back cane.
11.
Setting the depth and recline settings it is best done with the client
seated in the wheelchair. While the client is seated and supported in
the wheelchair, loosen the depth screws on the mounting plate and
set to the desired position. Tighten all screws to lock the backrest in
position. The backrest can be mounted asymmetrically, so be sure that
it is symmetrical if desired.
WIDTH
ADJUSTMENT
SCREWS
DEPTH/ANGLE
ADJUSTMENT SCREWS
TUBE
CLAMPING
SCREWS
LOOSEN THESE SCREWS
TO EXTEND LATERAL
QUICK RELEASE MOUNT
LATERAL CONTOUR
DEPTH ADJUSTMENT
FIXED MOUNT
DEPTH/RECLINE
ADJUSTMENT SCREWS.
USE THESE HOLES IN THE PLATE
AS A REFERENCE GUIDE FOR
SYMMETRICAL ADJUSTMENT ON
THE LEFT AND RIGHT SIDES.
TUBE CLAMPING
SCREWS.
MOUNT PINS IN THESE HOLES
FOR PEDIATRIC AND
ARMADILLO BACKS.
