10
Note:
Most of setting mode have restore factory defaults selection. The factory default value for
each setting is indicated by an asterisk "*".
You could use this barcode at the following status:
1
、
The scanner can not work. For example, it can not read barcodes.
2
、
You forget the settings you did to the scanner before, and you don't want to be affected by the
settings when you use the scanner.
3
、
After using a function which is not be used usually in the scanner.
Check Software Version
If you want to know the software version of TMCT-10
, should read the ‘Enter Setup’ and ‘Output
Software Version’ barcode:
Checking the software version is done at the enter setup mode, so after output the software
version, need to read ‘Exit without Save’ barcode.
Save Custom Settings
1. You may change factory defaults, and customize some functions suitable for your own
Enter Setup
Exit without Save
Output Software Version
Summary of Contents for TMCT-10
